tire repair strip

Steps for using the tire patch

1. Mark the tire puncture position and pull out the puncture

2. Use the tire repair probe to find out the direction of the hole penetration, insert and rotate in the direction of the hole to deal with the dust and debris in the hole

3. Cut one end of the rubber strip into an oblique opening and pass it into the front hole of the pin tool, so that the length of the rubber strip at both ends of the hole is basically the same

4. Insert the needle with rubber strip into the tire, make sure that the rubber strip is inserted 2/3 of the length (it must be determined that the cold patch rubber strip penetrates the carcass to avoid slipping out after inflation), and rotate the fork needle 360 degrees and pull it out Fork needle

5. For the tire repair strip remaining outside the tire, leave a length of 5mm on the tread, and subtract the rest